Flowers, leaves, fruits, roots and seeds – where machines alone are not enough.
Machines separate raw materials according to size, weight or behaviour in an air stream. However, they cannot distinguish a weed leaf from a herb leaf of the same size, or a piece of plastic from a flower petal. Therefore, where the highest level of purity is required, we combine mechanical cleaning with visual inspection carried out by a trained team.

When we use manual cleaning
- Foreign plant species and toxic weeds (e.g. ragwort, thorn apple, ragweed). They may be similar in size and weight to the target raw material, so they cannot always be removed by screening or air separation. Their presence may affect compliance with limits for pyrrolizidine and tropane alkaloids.
- Foreign objects such as strings, plastic film, feathers and hard plastic fragments. These should be absent from the finished raw material.
- Stems and small twigs that can pass lengthwise through the screen openings.
- Whole flowers, petals and premium raw materials that could be damaged by intensive mechanical processing.
- Raw materials from wild harvesting, new suppliers or batches where non-conformities have been identified during incoming inspection.
- Final inspection after mechanical cleaning, before milling or packaging.
How we work

Vibrating table – a hybrid method
The vibrating deck spreads the raw material into a thin, even layer and moves it steadily forward. Fine impurities pass through the mesh, while heavier particles are separated from the lighter product. At the same time, trained staff visually inspect the material and manually remove anything the machine cannot separate.
This combines the efficiency of mechanical processing with human visual assessment.
Inspection conveyors
The raw material moves in a single layer through the conveyor compartments, making every piece clearly visible. The conveyor speed is adjusted to the type of raw material and the level of contamination. This method works well for flowers, leaves and delicate materials, as well as for final inspection before milling or packaging.

Manual cleaning usually follows preliminary mechanical cleaning on the Petkus line or the Allgaier TSM 2000 screening machine. The machines remove most impurities, while the team focuses on what the equipment cannot identify. This helps achieve a cleaner raw material while keeping service costs lower.
What we remove
Foreign plant species, stems and unwanted plant parts, discoloured, clumped or mouldy material, insects and insect residues, foreign objects, as well as small stones and clods that have passed through earlier cleaning stages.


Principles that ensure effective inspection
- Thin layer and good lighting: every part of the raw material must be clearly visible.
- Two-stage control: sorting followed by an independent spot check carried out by another person.
- Reference materials at the workstation: photos of toxic plants and typical contaminants associated with the specific raw material.
- Staff rotation and regular breaks, as the effectiveness of visual inspection decreases during monotonous work.
- Hygiene: gloves, hair coverings, workwear and waste placed in clearly labelled containers.
- Mass balance: recording the weight before and after cleaning, as well as the weight and type of removed contaminants.
- If toxic plant contamination is suspected, we recommend laboratory testing of the batch after sorting.
How cooperation works
For an initial assessment, we need information about the type of raw material, batch size, the type of contamination present and the expected result after cleaning. For new or unusual materials, we recommend carrying out a technological trial.
